Elorang describes chip types and control methods for pressure transmitters
After years of research, the pressure transmitter has a certain fracture at the time of manufacture. The larger the index, the easier it is for the cutting to break. Because the cutting conditions of the pressure transmitter are very different, it is at the sensor joint. The cutting process produces a wide variety of different shapes of chips. These different cuttings represent the pressure transmitter's tightness. Here's a detailed analysis of which chips will be produced. .
1. When the pressure transmitter diaphragm and gauge are crimped, the uneven surface of the diaphragm needs to be cut. At this time, it will produce banded chips, that is, the surface is smooth, but the internal is very hard, generally only need to Speed ​​up when cutting and when larger tools are used.
2. Nodular chips, the outer surface is generally serrated, mainly due to the special nature of the head. Because pressure transmitters have different meter housings, the cutting tools used in manufacturing are also different. If the transmitter's cutting speed is too low at this time, it will produce nodal chips.
Then how to control these chips in the production process, why do you see the surface of the pressure transmitter housing is smooth, there is no pit due to chipping, because the cutting control technology is good.
1. A good smooth cutting groove must be used in the cutting of the shell so that the smooth radius groove can well control the flow force.
2, is the corresponding different original shell on the use of different angles.
3, if this shell material is not suitable for cutting, it needs to be replaced, so as to avoid pressure transmitter shell fracture too much, affect the quality.
Aeronol Fluid Control (Shanghai) Co., Ltd. is currently a number of well-known brands abroad, focusing on the marketing and sales of imported sensors, instrumentation, and adhere to the development direction of multi-species, multi-brand, differentiated and enthusiastic service. Welcome customers to negotiate.
1. When the pressure transmitter diaphragm and gauge are crimped, the uneven surface of the diaphragm needs to be cut. At this time, it will produce banded chips, that is, the surface is smooth, but the internal is very hard, generally only need to Speed ​​up when cutting and when larger tools are used.
2. Nodular chips, the outer surface is generally serrated, mainly due to the special nature of the head. Because pressure transmitters have different meter housings, the cutting tools used in manufacturing are also different. If the transmitter's cutting speed is too low at this time, it will produce nodal chips.
Then how to control these chips in the production process, why do you see the surface of the pressure transmitter housing is smooth, there is no pit due to chipping, because the cutting control technology is good.
1. A good smooth cutting groove must be used in the cutting of the shell so that the smooth radius groove can well control the flow force.
2, is the corresponding different original shell on the use of different angles.
3, if this shell material is not suitable for cutting, it needs to be replaced, so as to avoid pressure transmitter shell fracture too much, affect the quality.
Aeronol Fluid Control (Shanghai) Co., Ltd. is currently a number of well-known brands abroad, focusing on the marketing and sales of imported sensors, instrumentation, and adhere to the development direction of multi-species, multi-brand, differentiated and enthusiastic service. Welcome customers to negotiate.
Absorbent Socks,Absorbent Socks For Oil,Absorbent Socks For Water,Absorbent Socks Bunnings
Wuxi Huanawell Metal Manufacturing Co., Ltd. , https://www.wxzoyetsafety.com