Swing arm garbage truck knowledge sharing
Many of my friends do not understand what a swing arm type garbage truck is . In fact, the meaning of swinging the arm means that a uniform arm-type trash bucket can be transported by both left and right arms, which can be used for more than one vehicle. If you are not very clear, then look at the picture below and you will see it at a glance.
This kind of vehicle mainly uses Dongfeng, liberates the chassis, and then installs a uniform supporting hydraulic lifting assembly. Of course, this type of swing arm is used to run garbage, and its safety performance is high. Such a car with more than one bucket, a swing arm garbage truck can meet a large area of ​​garbage disposal. It is a nationally-used garbage bucket with a self-dumping function and hydraulic operation. The garbage bucket can be hung from the top to bottom, and it can be operated freely by looking at the work needs.
From the trash can we can be divided into four types: trapezoidal bucket, boat-shaped bucket, square bucket, sealed bucket. I personally prefer the seal hopper. It is a garbage bucket model that is more cost-effective for environmental protection. This will not cause secondary pollution and prevent leakage of flying pollution, so as to adapt to different environmental requirements.
Novice drivers while driving arm type garbage truck to be aware of its rules of operation: first the first point requires the driver to look around and observe the work site meets the requirements, followed by the bear to pull carts in the parking brake, hand throttle control pump speed. Then place a warning sign next to it, and then support the supporting leg cylinder on the ground, and confirm that the swing arm is lifted and dumped after the operation is confirmed. After the hopper transportation is completed, the following procedures shall be confirmed: 1. The garbage bucket lifting chain is in a relaxed state; 2. The garbage bucket and the swing arm rack are inserted into the positioning locking pin; 3. The outrigger cylinder is returned to the original position and a T-position locking pin is inserted. ; 4. The brake pad under the wheel has been removed.
When a car is driven for a period of time, it will require maintenance. The swing arm garbage truck is no exception. Drivers need to observe whether the parts in the car are clean, whether they are operating normally, find problems in time, and contact the sales team to strive for maximum output. .
Hydrophilic,Hydrophilic Silica With Dds Treatment,Hydrophobic Silica In Coatings,Silicon Dioxide With Hydrophobic Groups
Henan Minmetals East New Materials CO. LTD. , https://www.silicon-materials.com