Did your car have a "low temperature illness"? Take a look at how to solve

Flameout: Repeatedly starting the engine several times and sometimes it is not possible to start it. This is often caused by battery cold. The battery is most afraid of low temperature, and the capacity of the battery at low temperature is much lower than that at normal temperature. A battery used normally in a warm place will suddenly lose its electricity when it is cold. With the winter cold start, the power consumption is particularly large. Therefore, the use of vehicles for about two years is particularly good for this disease. In addition, too much carbon in the idle motor can make the car hard to start cold in the winter. Therefore, before the onset of cold winter, check the electrolyte level. If it is insufficient, add electrolyte and charge if necessary. If your car is parked in the open air or in a garage for several weeks, it is recommended that you remove the battery and store it in a warmer room to avoid icing damage. If it is difficult to start cold due to the idle motor coke, the idle motor must be cleaned and maintained.

Unable to start: The water temperature on the instrument panel is abnormal and the car cannot be started. This is often caused by freezing of antifreeze. The role of antifreeze in the winter is very important, if you do not replace the antifreeze in time, the car's cooling cycle will be affected, will cause the engine water temperature is too high, can not work, etc., but also cause the pump to freeze. Therefore, antifreeze is generally best replaced every two years. It is best to choose the same brand of antifreeze when supplementing. The less cars you run, the shorter the interval between antifreeze replacements. It is also necessary to remind riders that the washing liquid used to clean the front glass should also be replaced with a special cleaning fluid with antifreeze properties in winter to prevent it from being frozen.

Excessive noise: Excessive engine noise is often the result of engine oil being viscous and causing severe wear. Early wear and tear of the engine is a gradual, chronic disease. There will be no obvious performance at one time, but the damage will be greater. Engine oils are generally graded and use different grades of engine oil during the winter and summer seasons. If the summer is still sticky summer oil, the engine will cause early wear and tear. After the winter temperature drops, the viscosity of the oil will increase and the fluidity will deteriorate, leading to an increase in frictional resistance when the machine moves, causing early engine wear. Therefore, the summer oil should be replaced with winter oil in a timely manner, or use the common oil of the Four Seasons. In addition, if your car's motor oil has been used for a long time, the color is dark, and the adhesion is poor, you should also switch to high-quality, high-efficiency oil in time to protect the engine.

HIGH CLASS SYNTHETIC WAX

PVC high-efficiency composite lubricant H108 is a multi-functional lubricant produced from several high-end raw materials. It has both internal and external lubrication functions, balances the lubrication in the front, middle and late stages, improves the degree of plasticization, increases physical properties, and improves the surface gloss of the product, decrease separate out phenomenon, improve the cycle of cleaning the mold. It is suitable for the production and processing of all PVC rigid products except transparent products, especially for high-filled products, such as drainage pipes, wall panels, SPC floors, etc.

Method of use and addition amount: replace all lubricants in the formula - stearic acid, paraffin wax, Fischer-Tropsch wax, Polyethylene Wax, stearate, etc. only add this one product to reduce the probability of mismatching. the amount of addition is 20%-25% lower than the total amount of all internal and external lubricants added in the original formula .

High Class Synthetic Wax,Special Lubricant For Pvc Pipe,Pvc Transparent Product Lubricant,Pvc High-Efficiency Composite Lubricants

Hengshui Yimei New Material Technology Co.,Ltd , https://www.yimeipewax.com