Cheng Li fuel truck structure
Hubei Chengli Automobile Co., Ltd. is located in Suizhou. It is a designated professional automobile manufacturing enterprise of the National Development and Reform Commission and a modification base of Dongfeng Special Purpose Vehicle. The company also put innovation in the first place, registered Cheng Liwei trademark, including a series of models, today details on the next Cheng Li fuel car it!
From the appearance of the above figure, we can clearly see the structure of Chengli fuel tanker: car chassis, tanker, breathing valve, power take off, oil pump, delivery hose and other major structures, the following to introduce these Structural elements.
1. automobile chassis
The Chengli tank trucks were converted from Dongfeng and FAW Group's stereotyped chassis. The chassis of the car is an important part of the refueling car. Please read the attached "Automobile Chassis Manual" carefully when purchasing.
2. Tank truck
A lot of tank trucks are often seen driving on the highway. The red part will attract the attention of many people. The tank structure can be seen as an elliptical cylinder or body, and it must be made of high-quality steel plates to ensure its safety. . The whole tank is divided into two compartments and four compartments (or multiple compartments and multiple compartments). There are through holes at the lower end of the intermediate baffle, and each compartment is welded in the middle to strengthen the anti-wave partition to reduce the impact of the oil in the tank during driving and improve the tank. Body stiffness.
The tank body is the most important tanker, so it must be designed to prevent the effect of corrosion, so the tank body surface should be painted anti-rust paint and decorative paint, the middle of the tank is equipped with a container indicator, in the past When the tank is refueled or out of the tank, the volume in the tank can be directly indicated.
3. Breathing valve
In order to ensure the safety of the Chengli fuel tanker in the working process, the pressure in the tank is basically the same as the atmospheric pressure, and a breathing valve must be installed in the large lid of the tank. When the oil in the tank is heated to expand or when the oil pump is used to fill the tank When the oil level in the tank rises, the pressure increases. When the pressure in the tank is higher than 8 Kpa in the outside world , the valve plate on the breathing valve opens; When the oil pump is used to drain oil outward or the oil is cooled and contracted, the oil level drops, and the pressure decreases. When the tank pressure is lower than the ambient pressure 3Kpa , the valve plate under the breathing valve opens.
4. Power take-off
The Cheng Li refueling vehicle adopts a power take-off device matched with the chassis gearbox, which is also simple and convenient during operation and will not cause adverse effects.
5. Oil pump
The oil pump can be equipped with a self-priming centrifugal oil pump or a gear oil pump. See the oil pump instruction manual for its performance.
6. Delivery hose
The oil delivery hose adopts CRJ65 type quick joints, direct main type, end rubber ring seal, quick disassembly, convenient and reliable sealing. The oil delivery hose assembly is electrically conductive and safe to use.
   The above is the main structure of Chengli fuel truck. If you want to buy Cheng Liwei vehicle, please rest assured. Cheng Li Automobile Co., Ltd. has a strict quality system and strict after-sales service guarantee. It is available in 24 hours, allowing users to buy the rest assured. The peace of mind.
Paraffin Wax,Refined Paraffin Wax,Semi Refined Paraffin Wax,Pure Paraffin Wax
JAR HING PRODUCTS.,LTD , https://www.jarhingproducts.com